giftid.blogg.se - Bissell powerlifter rewind

It even keeps your air cleaner with a HEPA Sealed Allergen System. We hope these remedies bring you suction back to your PowerLifter Pet Rewind Vacuum. The BISSELL® Powerlifter Swivel Rewind Pet Vacuum gives a whole new meaning to convenient cleaning. Tackle difficult pet messes easier than ever with powerful suction, a lightweight design, and swivel steering.

Replace the bottom cover by reinserting the 6 screws using your Philips screwdriver.

When the brush roll is in, turn it to align the belt.

Replace the brush roll by placing the belt side of the brush in first, then turning the other end until it slides into place.

Place the new belt over the motor pulley and stretch the other end over the brush roll.

Inspect your belt, if it is broken or damaged it will need to be replaced.

If it doesn't spin freely it is time to replace your brush roll. To inspect the brush roll, set it on its end and spin it by flicking it once.Clear any debris on the brush roll or in the brush housing area and empty into a trash bin.Grab both ends of the brush and slide off the belt to remove it.Remove the 6 screws from the brush cover using your Philips screwdriver.With the machine unplugged, lay the vacuum back to expose the brush roll.Then replace the door by hooking the bottom in first and rotate it towards the machine. Press down on tab to remove filter cover. Post-motor filter is located below dirt tank. Close tank > Tank lid will click when it is securely closed. Insert thin flat filter (with tab) first > Then foam filter. Replace the Post Motor Filter in the unit with the handle facing you. Filters can be washed in warm water with mild dish soap > Allow to completely air dry (24 - 48 hours) before reinstalling.Gently tap the filter on the side of a trash bin to remove debris. The pleated Post Motor filter is NOT washable.Remove the filter by grasping the handle on the front of the filter and pulling out from vacuum.To access the Post Motor Filter, pull down on the latch on the front of your machine.Before replacing, make sure it is completely dry. The Pre-Motor Filters can be rinsed in warm water.While holding the filter over a trash bin, gently separate the filter layers.Below this, you can find the Pre-Motor Filters, Pinch the filter and lift to remove it.Remove the tank and check the suction inlet for any debris. Check if there is a clog in the machine.

Make sure the hose is secure in the foot of the suction opening.

Use a broomstick handle pushing towards the elbow of the hose to clear any potential clogs.Remove by pulling one end out of the base and turning the other end counterclockwise and out.Start by checking your hose for any cracks or holes.If your PowerLifter Pet Rewind vacuum has no or low suction, here are some steps to get that problem fixed.īefore you begin, you will need a Philips screwdriver.